CE 78 VERY FAST 1|2 H
Coating for water resistant plasterboard joints
Setting time 1|2 hour
ADVANTAGES
- Ideal for small worksite
- Suitable for cold and wet weather
- Very fine joint finish
DESCRIPTION
Product designed for making plasterboard joints. The wide range of setting times available means that it is easily adaptable to different worksite sizes.
Product designed for making plasterboard joints. The wide range of setting times available means that it is easily adaptable to different worksite sizes.
TECHNICAL CHARACTERISTICS
- Ahdesion: Strip adhesion > 1,000 g
- Cracking: No craking up to 5 mm thickness
- Density : 0,9
- Reaction to fire: A1
- Setting time: 1/2 h
PACKAGING
5 and 25 kg bags
5 and 25 kg bags
COMPOSITION
Powder filler based on plaster, calcium carbonate, resin and various additives.
The paste obtained is white.
Powder filler based on plaster, calcium carbonate, resin and various additives.
The paste obtained is white.
SUITABLE SUBSTRATES
All types of plasterboard with or without insulation (glass wool, rock wool, polystyrene) with tapered edges and paper face.
All types of plasterboard with or without insulation (glass wool, rock wool, polystyrene) with tapered edges and paper face.
STORAGE
9 months in original unopened package, protected from damp.
9 months in original unopened package, protected from damp.
SUBSTRATE PREPARATION
Plasterboard must be attached in conformity with DTU 25.41 and 25.42
Cuts made into plasterboard must be on the bevel and dusted
Plasterboard must be attached in conformity with DTU 25.41 and 25.42
Cuts made into plasterboard must be on the bevel and dusted
MIXING RATIO
From 10 to 11 l of water per 25 kg sack. 1 volume of water + 2,5 volumes of powder.
From 10 to 11 l of water per 25 kg sack. 1 volume of water + 2,5 volumes of powder.
USE
Before jointing fill gaps between boards and any irregular joints and repair any damaged board.
Apply manually by using a 10 or 15 cm filling knife and apply the tape - milled face against the board. Then apply a finish coatn allow to dry and finish to cover the tape.
Also cover screw heads.
Apply a tape into the ceiling joins and ensure that the concrete is free of any signs of mould-release oil.
For vertical protruding angles use a reinforced tape (metal side against the board) or a metal angle bead.
Before jointing fill gaps between boards and any irregular joints and repair any damaged board.
Apply manually by using a 10 or 15 cm filling knife and apply the tape - milled face against the board. Then apply a finish coatn allow to dry and finish to cover the tape.
Also cover screw heads.
Apply a tape into the ceiling joins and ensure that the concrete is free of any signs of mould-release oil.
For vertical protruding angles use a reinforced tape (metal side against the board) or a metal angle bead.
DRYING TIME
Second coat may be applied 4 hours after application of the first coat.
Second coat may be applied 4 hours after application of the first coat.
CONSUMPTION
Approximately 350 g/m² of plasterboard
Approximately 350 g/m² of plasterboard
COVERING
Primer undercoat for plasterboard.
Plaster-based smoothing filler.
Primer undercoat for plasterboard.
Plaster-based smoothing filler.
AVAILABLE DOCUMENTATION
DTU 25.41
DTU 25.42
CE Marking
DTU 25.41
DTU 25.42
CE Marking
Follow us 
